Now available, our 12A turbo manifold. Length, tubing diameter, placement of turbocharger, and waste gate are all subject to change for your specific fitment needs. A standard list of materials and fabrication procedures are listed below.
304L standard .120" wall tubing is used but, a 321SS upgrade is available if needed for larger turbocharger selections.
The engine and turbo flanges are 1/2" thick to ensure a warp free service life.
Secondary argon back purged welding is a standard on all of our manifolds including this 12A edition.
In addition we weld every flange inside and out, and every manifold is braced to ensure a quality product.
Exhaust gas temperature bungs/plugs are available.
Heat management coatings are available at additional cost.
|
|
